Hks electronic valve controller 2 manual

 · HKS Electronic Valve Controller - vacuum line connection. Thread starter jixaw; Without looking at the specific user manual of your boost controller I can't give you a specific or definitive answer but if it works like a Greddy Profec or similar then personally I'd place the solenoid in-line with the wastegates boost reference line.  · Quick Manual ELECTRONIC VALVE CONTROLLER types Turn on the EVC-S @To turn on (or off) the EVC- Since the introduction of their first boost controller in, HKS have been at the pinnacle of electronic boost control. Fresh from HKS, the "EVC-S" is from the EVC product series for price-conscious customers. This EVC-S utilises a stand alone. ELECTRONIC VALVE CONTROLLER IV SET UP INSTRUCTIONS PART # RA RA HKS U.S.A., INC. Read this entire manual to understand how the EVC IV functions before beginning the installation process. Do not attempt to Install or adjust the EVC IV without thorough knowledge of how this unit works.

HKS EVC V. The EVC V is a user-friendly, full-featured digital electronic boost controller that utilizes a precision "closed-loop" boost regulating stepping motor. Stepping motors are used because they can handle higher boost levels and are quicker to react to various conditions, thus offering quicker boost response and higher stable boost. Quick Manual ELECTRONIC VALVE CONTROLLER types Turn on the EVC-S @To turn on (or off) the EVC-S, press the center of the switch longer @ Press the right side of the switch to set the Response Value. ("RSP" appears on the monitor.) RSP Boost n Increase ('Q Press the upper or lower side of the switch to enter a number. Decrease the Response Va lue. Boost Controller- Automotive Turbocharged Engine Vehicle that operates on a DC 12V negative ground. －AK ・A fuel controller (e.g. F-CON, AIC, etc) may be needed when raising boost pressure with the EVC Boost Controller.

Buy HKS EVC-S Electronic Boost Controller typeS (AK): Boost Controllers - www.doorway.ru ✓ FREE DELIVERY possible on eligible purchases. Connect the red wire (2-pin harness) from the EVC to a volt ignition source. Utilizing a voltmeter, find a wire that receives at least EVC7Electronic Valve Controller 7. EVC7 Map ON/OFF Can I install EVC in my KEI-car? EVC is not controlling the boost, and the boost doesn't go up.